All codes

bms_f001_hw_over_current

Do not drive

Tesla · BMS system

Battery Management System — Hardware Overcurrent Trip

What it means

Pack current exceeded the hardware overcurrent threshold — a hard limit enforced by dedicated circuitry, not just software. Something pulled or pushed far more current than the pack allows, and the protective hardware disconnected the battery. Driving, charging, and low-voltage support are all blocked.

Symptoms

  • "Service required — Pull over safely" warning
  • Sudden loss of power
  • Single chime with a battery-cutoff warning
  • May follow a hard acceleration, fault, or short event

Likely causes (by probability)

  1. 1.Short circuit or fault in the drive inverter or high-voltage wiringMedium
  2. 2.Drive-unit failure drawing excessive currentMedium
  3. 3.Current-sensor or detection-circuit fault (false trip)Low
  4. 4.Charging fault pushing excessive current into the packLow

What you can check yourself

  • 01Pull over and stop — a hardware overcurrent trip means the protection already saved the car once.
  • 02Do not repeatedly restart; each retry re-closes contactors into a possible fault.
  • 03Note what the car was doing at the moment (accelerating, charging, parked) for the technician.
  • 04No DIY inspection of high-voltage components.

EV systems involved in bms_f001_hw_over_current

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Tow, don't drive. A hardware-level overcurrent trip needs a technician to find what pulled that current before the car runs again.

Estimated repair cost

Dealer / service center

— – —

Covered under battery or drive unit warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site