All codes

bms_a076_sw_dch_while_charging

Do not drive

Tesla · BMS system

Battery Management System — Battery Discharging During Charge Session

What it means

The car is supposed to be gaining energy while plugged in, but the BMS measured the pack actually losing charge during the session. The incoming power is not keeping up with what the car is consuming — or something is pulling energy backward. Charging is disabled until the condition clears.

Symptoms

  • "Low power — Unable to charge the battery" message
  • State of charge drops (or fails to rise) while plugged in
  • Charging unavailable
  • Often appears with a weak or failing charging source

Likely causes (by probability)

  1. 1.Charging source delivering far less power than expected (weak circuit, failing EVSE)High
  2. 2.Heavy onboard loads (heat/AC, battery heating) exceeding available charge powerMedium
  3. 3.Faulty current measurement or charge-control hardwareLow
  4. 4.Onboard charger or PCS fault wasting incoming powerLow

What you can check yourself

  • 01Try a different outlet, EVSE, or charging station — if the alert vanishes, the problem was the power source, not the car.
  • 02Reduce cabin climate load while charging on a marginal circuit.
  • 03Check the charge screen: if amps in are near zero or negative, the source is the prime suspect.
  • 04If the alert appears on multiple known-good chargers, schedule service to check the onboard charging hardware.

EV systems involved in bms_a076_sw_dch_while_charging

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Do not drive

Charging is blocked, so treat remaining range as finite. Rule out the charging source first, then head to service if it follows the car.

Estimated repair cost

Dealer / service center

— – —

Often turns out to be the charging equipment (no vehicle cost); if vehicle hardware is at fault, covered under battery warranty in many cases.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site