bms_w017_sw_brick_ov
Do not driveTesla · BMS system
Battery Management System — Cell Group Voltage Too High
What it means
At least one cell group ("brick") inside the pack is reporting a voltage above the maximum safe cell voltage, so the BMS has shut down high-voltage operation — no driving, no charging, no 12V support from the pack. Over-voltage at the cell level can permanently damage cells, which is why the car takes itself out of service.
Symptoms
- Car won't drive or charge
- "Service needed — pull over safely" warning
- Often appears at the end of a charging session
- May come with other voltage or imbalance alerts
Likely causes (by probability)
- 1.A cell group genuinely overcharged or out of balance with the rest of the packHigh
- 2.A voltage-sense fault on a monitoring board reporting false high voltageMedium
- 3.A charging-system fault that pushed the pack too highLow
What you can check yourself
- 01Stop charging and don't try to drive — record exactly when in the charge cycle the alert appeared.
- 02Photograph all alerts and save them for service.
- 03If you have Scan My Tesla, note which brick shows the high reading — useful data for Tesla.
- 04There is no DIY fix: cell-level voltage faults are diagnosed inside the sealed pack by Tesla Service.
EV systems involved in bms_w017_sw_brick_ov
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Park it and arrange service. Continuing to charge or drive with an over-voltage cell group risks real pack damage.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f080_sw_int_hv_disconnectBattery Management System: Internal High-Voltage Disconnect Detected
- bms_f171_sw_pack_motor_mismatchBattery Management System: Pack and Motor Configuration Mismatch
- bms_w031_sw_precharge_res_hotBattery Management System — Precharge Resistor Overheated
- bms_w133_sw_service_toolBattery Management System — Invalid Request From a Service Tool