All codes

bms_f003_hw_module_alarm

Do not drive

Tesla · BMS system

Battery Management System — Battery Module Hardware Alarm

What it means

One or more battery modules have raised their hardware alarm line to the BMS — a hardwired distress signal from inside the pack. The result is a protective shutdown of driving, charging, and low-voltage support. One quirk worth knowing: on older Model S/X, a very weak low-voltage battery can set this alarm falsely.

Symptoms

  • "Service required — Pull over safely" warning
  • Car cannot drive or charge
  • Single chime with a battery-cutoff warning
  • On S/X, may coincide with a dying 12V battery

Likely causes (by probability)

  1. 1.Genuine module-level fault (cell voltage, temperature, or internal error)Medium
  2. 2.Very low 12V/low-voltage battery causing a false module alarmMedium
  3. 3.Wiring fault on the module alarm lineLow
  4. 4.Monitoring board failure inside a moduleMedium

What you can check yourself

  • 01Check the 12V battery first — on Model S/X an aging 12V is a classic false trigger, and it is the one DIY-friendly angle here.
  • 02If the 12V is healthy or replacing it does not clear the alarm, stop — the fault is inside the pack.
  • 03Do not open or probe the battery pack.
  • 04Note any preceding symptoms (range loss, other alerts) for service.

EV systems involved in bms_f003_hw_module_alarm

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Do not drive

Rule out the 12V battery (cheap, quick), then tow to service — a genuine module alarm means pack-level diagnosis.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; if it is just the 12V battery, that is an inexpensive fix. Out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site