All codes

bms_f104_hw_bmb_enumeration

Do not drive

Tesla · BMS system

Battery Management System: Battery Monitoring Board Enumeration Failure

What it means

At startup, the BMS counts and identifies every BMB in the pack — a process called enumeration. This alert means one or more boards failed to check in during startup, so the BMS cannot confirm it is monitoring the whole pack and refuses to enable high voltage.

Symptoms

  • "Service required / Schedule service" message
  • Car will not drive, charge, or support low-voltage systems
  • Startup sequence stalls before contactors close

Likely causes (by probability)

  1. 1.Failed BMB not responding at startupMedium
  2. 2.Break in the internal comm daisy-chain wiring between boardsMedium
  3. 3.Connector corrosion or water ingress inside the packLow

What you can check yourself

  • 01Try one full power-down and single restart — enumeration glitches occasionally clear
  • 02Note any recent pack service, water exposure, or underbody impact
  • 03Check for companion alerts bms_f050 (BMB MIA) and bms_f100 (BMB reset)
  • 04Pack-internal hardware only — no owner action beyond logging symptoms

EV systems involved in bms_f104_hw_bmb_enumeration

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Not drivable while active. Arrange service; enumeration failures almost always mean pack-internal hardware work.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site