bms_a097_sw_bmb_over_can_communication
Safe to driveTesla · BMS system
Battery Management System — Cell Monitor Data Arriving Late (CAN)
What it means
The battery monitoring boards (BMBs) report cell voltages and temperatures to the BMS over a CAN link, and some of those data frames are arriving late or not at all. The BMS papers over the gaps with substituted values so the car keeps working, but it logs this alert so service knows the data feed is flaky.
Symptoms
- No driver-visible symptoms
- Silent center-display alert
- Found mainly in service logs
- May accompany other BMB communication alerts
Likely causes (by probability)
- 1.CAN bus congestion or wiring issue on the monitoring networkMedium
- 2.Marginal connector on a monitoring boardMedium
- 3.A monitoring board beginning to failLow
- 4.Software timing issueLow
What you can check yourself
- 01Check whether the alert is a one-off or recurring — recurrence matters more than the event itself.
- 02Look for companion BMB alerts (communication, data integrity) that indicate a developing chain problem.
- 03Note any recent pack or high-voltage service.
- 04No DIY access here — the monitoring network lives inside the sealed pack.
EV systems involved in bms_a097_sw_bmb_over_can_communication
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Informational. Mention it at your next service, especially if it recurs — degraded cell data can mask real battery issues.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w166_sw_ahtobecharged_imbalBattery Management System — Cell Group Charge Imbalance
- bms_a082_sw_ctr_force_openBattery Management System — Contactors Forced Open by Alert
- bms_a167_sw_fc_partial_weldBattery Management System — One Fast-Charge Contactor Welded
- bms_f054_sw_current_sensorBattery Management System: Current Sensor Fault