All codes

bms_a139_sw_dc_link_v_irrational

Do not drive

Tesla · BMS system

Battery Management System — DC Bus vs Pack Voltage Mismatch

What it means

The BMS compared the voltage inside the pack to the voltage on the DC bus (the high-voltage rail the rest of the car uses) and the two do not line up the way physics says they should. One of the measurements — or something in between, like a contactor — is misbehaving, so the car disables driving, charging, and low-voltage support.

Symptoms

  • Car cannot drive or charge while active
  • Silent center-display alert
  • May appear at startup during the contactor self-test
  • May accompany contactor or voltage-sensing alerts

Likely causes (by probability)

  1. 1.Faulty DC-link or pack voltage measurement circuitMedium
  2. 2.Contactor not closing cleanly, leaving the bus at an unexpected voltageMedium
  3. 3.Pre-charge circuit faultMedium
  4. 4.Wiring fault in the voltage sense pathLow

What you can check yourself

  • 01Try a full sleep cycle — a one-off sensing glitch sometimes clears.
  • 02Check companion alerts (contactor, sensing) to give service a head start.
  • 03Do not attempt any measurement or inspection of high-voltage components.
  • 04If the car is stranded, arrange a tow rather than repeated restart attempts.

EV systems involved in bms_a139_sw_dc_link_v_irrational

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

High voltage stays locked in the pack until the numbers make sense again. Service or tow if a sleep cycle does not clear it.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site