bms_f065_sw_brick_low_capacity
Do not driveTesla · BMS system
Battery Management System: Brick Low Capacity
What it means
The BMS tracks each brick's calculated amp-hour capacity (CAC) and found one brick storing meaningfully less energy than its neighbors. That is the classic signature of an aging or failing cell group — the pack is only as strong as its weakest brick, so usable capacity and performance drop for the whole pack.
Symptoms
- Noticeably reduced range
- Driving or charging may be disabled in severe cases
- Often no customer text — may only appear in service logs until it worsens
Likely causes (by probability)
- 1.Genuine capacity loss in one brick (aging, cell damage, or manufacturing defect)High
- 2.Severe cell imbalance making capacity calculation look lowMedium
- 3.Measurement error in the capacity calculationLow
What you can check yourself
- 01Use Scan My Tesla to compare per-brick capacity/impedance data and identify the weak brick — screenshot it for your warranty claim
- 02Check for companion imbalance alerts (bms_f164, bms_f166) — if the pack is just out of balance, a few full charge cycles may help
- 03Do one slow AC charge to 100% and let the car sit plugged in so the BMS can rebalance, then recheck
- 04Never attempt to open the pack or replace cells yourself
EV systems involved in bms_f065_sw_brick_low_capacity
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
If the car still drives, you can use it gently — but document the capacity loss and push for a warranty evaluation promptly.
Estimated repair cost
Dealer / service center
— – —
This is exactly what the 8-year battery warranty exists for — capacity loss below Tesla's retention threshold should be covered; get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_u004_charge_cable_connectedBattery Management System: Charge Cable Still Connected
- bms_w039_sw_dc_link_over_voltageBattery Management System — Over-Voltage on the High-Voltage Bus (Outside the Pack)
- bms_w152_sw_pos_contactor_weldedBattery Management System — Positive Contactor Welded Shut
- bms_a063_sw_chargeport_faultBattery Management System — Charge Port Fault, Charging Unavailable