All codes

bms_w018_sw_brick_uv

Do not drive

Tesla · BMS system

Battery Management System — Cell Group Voltage Too Low

What it means

At least one cell group ("brick") inside the pack is reporting a voltage below the minimum safe level, so the BMS has shut the high-voltage system down — the car can't drive, charge, or support the 12V system from the pack. Deeply discharged cell groups can be permanently damaged, which is why the car locks itself out.

Symptoms

  • Car won't drive or charge
  • Warning may appear after the car sat for a long time at a very low state of charge
  • Possible earlier "very low battery" warnings before shutdown
  • May appear alongside cell imbalance alerts

Likely causes (by probability)

  1. 1.A weak or failing cell group that self-discharges faster than the restHigh
  2. 2.The pack was left at very low state of charge for an extended periodMedium
  3. 3.A voltage-sense fault reporting a falsely low readingLow

What you can check yourself

  • 01Try plugging the car into AC charging and leave it — if the pack accepts charge, the BMS may recover the low group slowly.
  • 02Note how long the car sat and at what charge level before the alert appeared.
  • 03Photograph all alerts for the service visit.
  • 04Don't attempt pack-level work — under-voltage cell diagnosis happens inside the sealed pack at Tesla Service.

EV systems involved in bms_w018_sw_brick_uv

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

Deep dive: what owners should know

A "brick" is Tesla's term for a cell group — a parallel batch of cells wired together to form one voltage step in the series string — and the string is only as usable as its weakest step. BMS_W018 flags that one brick's voltage has fallen below the warning threshold, and while the word "warning" softens the code, the physics underneath deserves respect: a chronically low brick is the earliest readable signal of a cell group going bad. The voltage of any group sags under load, and the BMS expects that sag to stay within a band predicted by the pack's state of charge, temperature, and health model. When one group sags more than the model predicts — sitting visibly lower than its neighbors at rest, or dipping disproportionately under acceleration — the BMS logs this warning while continuing to manage around the weakling. The cause tree is short. The most common is genuine cell degradation: one group aging faster than its neighbors, losing capacity and developing higher internal resistance, producing exactly this low-voltage signature. Next is sensing trouble — the voltage-sense harness or a monitoring board reporting a group falsely low, which the neighboring-code evidence usually reveals. Rarely, a group is chronically under-charged by a balancing system that cannot keep up, though modern balancing strategies make persistent undercharge the least likely story. For owners with OBD access, the signature is unmistakable: one brick tracking below its neighbors at rest, dipping further under load, recovering slowly after. That reading, logged over days, is the difference between a warranty claim with evidence and a warranty conversation without it — and on a pack still under the battery warranty, a persistent weak-brick warning is very much a warranty conversation. The warning level means the car is compensating; the follow-through is what converts a warning into a managed outcome rather than a limp mode later.

Severity

Do not drive

Try charging first, but if the car won't accept charge or the alert persists, it needs Tesla Service — likely a battery-warranty conversation.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site