All codes

bms_a151_sw_external_isolation

Do not drive

Tesla · BMS system

Battery Management System — External Isolation Fault

What it means

With the contactors closed, the BMS measured high-voltage isolation to chassis below the safe threshold — and the leak appears to be outside the battery pack, somewhere in the car's high-voltage wiring or components (drive units, heaters, compressor, charge port, cabling). Because this is a shock-hazard category, the car blocks driving, charging, and low-voltage support.

Symptoms

  • "Vehicle may not restart — Service required" message
  • Car refuses to drive or charge
  • Single chime with a warning icon
  • May follow collision, water exposure, or accessory failure

Likely causes (by probability)

  1. 1.Moisture or damage in a high-voltage component (AC compressor, PTC heater, charge port, junction box)Medium
  2. 2.Damaged high-voltage cabling (rodent, impact, chafing)Medium
  3. 3.Failed drive-unit or inverter insulationLow
  4. 4.False reading from the isolation monitor itselfLow

What you can check yourself

  • 01Do not touch orange cabling or high-voltage components — visual checks from a distance only.
  • 02Tell service about any recent impacts, rodent signs, or flood exposure.
  • 03A sleep cycle may clear a false positive; a returning alert is a real leak until proven otherwise.
  • 04Technicians isolate the fault by disconnecting components one at a time — leave that process to them.

EV systems involved in bms_a151_sw_external_isolation

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Park it and call service. External isolation faults are usually a component or cable issue — fixable, but only with proper test equipment.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site