bms_f002_hw_over_voltage
Do not driveTesla · BMS system
Battery Management System — Hardware Overvoltage Trip
What it means
Pack voltage exceeded the hardware overvoltage threshold, tripping dedicated protective circuitry that disconnects the battery. This is the hardware backstop firing — meaning the software limits were already past. Driving, charging, and low-voltage support are blocked.
Symptoms
- "Service required — Pull over safely" warning
- Car loses drive power
- Charging disabled
- Single chime with a battery-cutoff warning
Likely causes (by probability)
- 1.Charging system fault that drove pack voltage too highMedium
- 2.Regen event pushing bus voltage beyond limitsMedium
- 3.Voltage-sensing fault causing a false tripLow
- 4.Failing high-voltage hardware (PCS, contactors)Low
What you can check yourself
- 01Pull over safely and park — do not continue driving on a tripped hardware protection.
- 02Note whether it happened while charging or driving, and the state of charge.
- 03Do not attempt to reset or bypass any high-voltage protection.
- 04Arrange service or a tow; capture companion alerts for the technician.
EV systems involved in bms_f002_hw_over_voltage
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Hardware protections trip for real reasons. Have the car towed to service for a high-voltage system check.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f123_sw_internal_isolationBattery Management System: Low Internal Isolation
- bms_u014_not_enough_pwr_to_heatBattery Management System — Not Enough Power to Heat the Battery While Charging
- bms_w059_sw_pack_voltage_sensingBattery Management System — Pack Voltage Doesn't Match the Sum of Cell Voltages
- bms_w162_sw_fc_prechg_too_slowBattery Management System — Fast-Charge Precharge Too Slow