All codes

bms_a152_isolation_in_dc_charge

Do not drive

Tesla · BMS system

Battery Management System — Low Isolation Detected During DC Charging

What it means

During a DC fast-charging session, the BMS measured isolation resistance on the high-voltage bus below the acceptable threshold. Charging stops and will not resume until the cable is unplugged and the alert clears. The leak could be on the car side — or, importantly, on the charging station side.

Symptoms

  • DC fast charging session terminates
  • Car will not charge until unplugged
  • Silent center-display alert
  • May only happen at one particular station

Likely causes (by probability)

  1. 1.Faulty or wet DC charging station leaking to groundMedium
  2. 2.Car-side isolation leak that only shows under charge loadMedium
  3. 3.Moisture in the charge port or inletMedium
  4. 4.Isolation monitor false readingLow

What you can check yourself

  • 01Try a different station (different network, different location). If the alert only happens at one site, the station is the problem — report it to the operator.
  • 02Check the charge port for visible moisture and let it dry naturally.
  • 03Verify AC charging still works; a car-side leak usually affects both.
  • 04If the alert follows the car across stations, schedule service for an isolation test.

EV systems involved in bms_a152_isolation_in_dc_charge

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

DC charging is blocked until resolved. Rule out the station first; if it is the car, do not delay the isolation diagnosis.

Estimated repair cost

Dealer / service center

— – —

If vehicle-side, covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site