bms_a158_sw_hvp_hvi_comms
Do not driveTesla · BMS system
Battery Management System — High-Voltage Processor Communication Lost
What it means
The BMS has lost its message link with the high-voltage processor (HVP) — the partner controller that manages contactors, current measurement, and high-voltage switching. Without that conversation, the BMS cannot safely operate the pack, so driving, charging, and low-voltage support are all blocked.
Symptoms
- "Vehicle may not restart — Service required" message
- Car will not drive or charge
- Single chime with a warning icon
- May appear at wake-up or after a software update
Likely causes (by probability)
- 1.HVP crashed or failed to wakeMedium
- 2.CAN wiring/connector fault between the BMS and HVPMedium
- 3.Low-voltage supply issue at the HVPMedium
- 4.Failed HVP hardwareLow
What you can check yourself
- 01Do a full sleep cycle — a hung HVP often comes back on a clean wake.
- 02Check low-voltage battery health if it recurs.
- 03Check for companion communication alerts that indicate a wider network issue.
- 04Do not attempt to reseat high-voltage connectors yourself.
EV systems involved in bms_a158_sw_hvp_hvi_comms
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
If a sleep cycle does not restore communication, arrange service or a tow — the pack stays offline without its partner controller.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_u011_fast_charger_problemBattery Management System — DC Fast Charging / Supercharging Blocked
- bms_w056_sw_module_temp_outlierBattery Management System — One Module Reporting an Odd Temperature (Log)
- bms_w160_sw_brick_overchargedBattery Management System — Cell Group Overcharged (Early Flag)
- bms_a076_sw_dch_while_chargingBattery Management System — Battery Discharging During Charge Session