bms_w100_hw_bmb_reset
Do not driveTesla · BMS system
Battery Management System — Battery Monitoring Board (BMB) Reset Event
What it means
One of the battery monitoring boards inside the pack reported a power-on reset — meaning it lost power or hit an internal error and rebooted. A resetting BMB can drop its cell readings, which is why the car may shut down or refuse to operate the high-voltage system. It can be a one-off power glitch or a sign of a failing board or wiring.
Symptoms
- Vehicle shuts down or won't restart
- "Pull over safely" warning
- Unable to charge
- May be intermittent
Likely causes (by probability)
- 1.Power interruption to the BMB (wiring, connector, low 12V)Medium
- 2.A failing BMB with internal errorsMedium
- 3.Water intrusion or corrosion in the pack harnessLow
What you can check yourself
- 01Check the 12V battery first — module power problems often trace back to it.
- 02Try one full power-off and restart; record whether the event repeats.
- 03Note any recent water exposure or pack-area service.
- 04BMB hardware is inside the sealed pack — Tesla Service only.
EV systems involved in bms_w100_hw_bmb_reset
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
A monitoring board rebooting mid-operation is taken seriously by the car. One restart attempt, then tow to service if it returns.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a051_sw_hvc_vref_badBattery Management System — High-Voltage Controller Reference Voltage Off
- bms_a143_sw_cac_changeBattery Management System — Large Capacity Estimate Update
- bms_f028_sw_drive_iso_stddevBattery Management System: High Isolation Reading Variance While Driving
- bms_f110_sw_module_vsenseBattery Management System: Module Voltage Sensing Mismatch