All codes

bms_a168_sw_fc_full_weld

Do not drive

Tesla · BMS system

Battery Management System — Both Fast-Charge Contactors Welded

What it means

Both contactors in the DC fast-charge path have welded shut, leaving the pack permanently tied to the charge-port side of the high-voltage system with no way to disconnect it. That defeats a key safety boundary, so the car blocks driving, charging, and low-voltage support outright.

Symptoms

  • "Unable to charge" message; car will not operate normally
  • Driving, charging, and low-voltage support blocked
  • Charge port door must be closed for any drive attempt
  • Detected at startup self-test

Likely causes (by probability)

  1. 1.Major fault current during a DC fast-charge session fusing both contactorsMedium
  2. 2.Charging station malfunction delivering damaging currentMedium
  3. 3.Progressive contactor damage finally detectedLow
  4. 4.False detection from a weld-sense circuit faultLow

What you can check yourself

  • 01Do not attempt fast-charge hardware inspection — lethal voltage.
  • 02Close the charge port door and arrange a tow rather than repeated start attempts.
  • 03Tell service which DC station was used last; station faults sometimes cause this.
  • 04Keep the car parked and dry until recovered.

EV systems involved in bms_a168_sw_fc_full_weld

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Hard stop — the fast-charge path cannot disconnect. Tow to Tesla Service for contactor replacement.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site