All codes

bms_a169_sw_fc_pack_weld

Drive with caution

Tesla · BMS system

Battery Management System — One Pack and One Fast-Charge Contactor Welded

What it means

The BMS self-test found a welded contactor on each side of the high-voltage system: one main pack contactor and one fast-charge contactor are fused shut. Each path still has one working contactor, so the car usually operates — but two safety disconnects are degraded at once, and that combination gets attention.

Symptoms

  • "Unable to charge" message related to fast charging
  • DC fast charging unavailable
  • Charge port door must be closed before driving
  • Normal driving and AC charging usually still work

Likely causes (by probability)

  1. 1.A shared overcurrent event stressing both contactor pathsMedium
  2. 2.Age and cycle wear on multiple contactorsMedium
  3. 3.Weld-detection circuit fault producing combined false positivesLow

What you can check yourself

  • 01Confirm AC charging works to keep the car usable.
  • 02Do not delay service — two degraded disconnects is double the risk of the single-weld alerts.
  • 03No DIY anywhere near the contactors; high voltage throughout.
  • 04Share any history of fast-charge faults or station errors with the technician.

EV systems involved in bms_a169_sw_fc_pack_weld

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Drive with caution

Drivable on AC charging, but book service promptly — two welded contactors means your safety margins are worn thin.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site