All codes

bms_a174_sw_charge_failure

Do not drive

Tesla · BMS system

Battery Management System — Charging Failed to Start

What it means

The BMS hit a condition that prevented it from starting a charge session at all. The cause can be on the car side (contactors, charge port, a blocking alert) or the charger side. While the condition persists, the car will not charge — and depending on the underlying block, driving and low-voltage support may also be restricted.

Symptoms

  • "Unable to charge — Disconnect and retry" message
  • Charge session never starts
  • Single chime with a warning icon
  • May work on some chargers and not others

Likely causes (by probability)

  1. 1.Another active BMS alert blocking the charge sessionMedium
  2. 2.Charge port or cable handshake failureMedium
  3. 3.External charger (EVSE) fault or incompatibilityMedium
  4. 4.Contactor or high-voltage interlock issueLow

What you can check yourself

  • 01Disconnect fully, do a full sleep cycle, and retry on a different, known-good charger.
  • 02Check for companion alerts — a blocking alert is the usual root cause.
  • 03Try both AC and DC charging to isolate which path fails.
  • 04Inspect the port and cable connector visually for damage or debris.

EV systems involved in bms_a174_sw_charge_failure

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

Deep dive: what owners should know

There is a special category of EV frustration reserved for the charging session that begins with every outward sign of success — port light white, cable locked, the app showing charging — and then, minutes or seconds later, simply ends. BMS_A174 is the BMS's own summary of that failure: it commanded or permitted a charge, the session could not establish or sustain, and the attempt was logged as a failure. The code's breadth is its defining feature — it covers the whole space of "charging did not work" from the battery's vantage point — which means the code itself is the start of diagnosis rather than the end. The organizational trick that tames it is asking one question first: did the failure happen at the start of the session, or mid-session? Start-of-session failures cluster around the handshake and the initial contactor closing: pilot and proximity signaling, station compatibility, the pre-charge sequence that brings the charging hardware up to bus voltage before full current flows. A precharge that fails or times out logs this code and leaves the port light flashing its disappointed colors. Mid-session failures point elsewhere: thermal limits reached as the battery warms under load, voltage or current regulation disagreements between the BMS and the station, isolation dips under stress, or grid-side events that interrupt the station itself. The companion evidence matters enormously: CP-family codes alongside mean the port and its communication deserve attention; thermal codes alongside mean the cooling loop; nothing alongside means the station itself is a legitimate suspect and a different charger is the cheapest experiment in EV diagnostics. One habit worth building: photograph or screenshot the port light and app state when a session fails. The failure mode's timing, the light color, and the station identity in one image short-circuit an enormous amount of diagnostic ambiguity.

Severity

Do not drive

With charging blocked, manage remaining range carefully. If a different charger and a sleep cycle do not help, book service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site