bms_f074_sw_charging
Do not driveTesla · BMS system
Battery Management System: Charging Fault
What it means
The BMS detected a problem with the charging system and stopped charging. This is a general charger fault — the specific detail (regulation, communication, hardware) is stored in the alert log data, and there is usually a more specific companion alert alongside it.
Symptoms
- Charging stops or refuses to start
- Charge port light may show red/amber
- Often no customer text — appears in logs with companion alerts
Likely causes (by probability)
- 1.Onboard charger hardware faultMedium
- 2.Charge port, cable, or inlet connection problemMedium
- 3.Charger regulation issue (see bms_f077)Low
What you can check yourself
- 01Try a completely different charger — wall connector, public AC, and Supercharger — to isolate car vs. equipment
- 02Inspect the charge port pins for debris, corrosion, or bent contacts (car off, flashlight only)
- 03Check for companion alerts like bms_f052 (charger MIA) or bms_f077 (regulation)
- 04Power-cycle the car and retry once with a known-good charger
EV systems involved in bms_f074_sw_charging
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
The car cannot charge reliably, which effectively strands you. Isolate whether it is car or equipment, then schedule service if it follows the car.
Estimated repair cost
Dealer / service center
— – —
Charge port repairs are moderate; onboard charger replacement is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a169_sw_fc_pack_weldBattery Management System — One Pack and One Fast-Charge Contactor Welded
- bms_f059_sw_pack_voltage_sensingBattery Management System: Pack Voltage Sensing Mismatch
- bms_f152_sw_pos_contactor_weldedBattery Management System: Positive Contactor Welded
- bms_w011_hw_illegal_ctr_reqBattery Management System — Contactor Close Request Blocked by Safety Logic