bms_a178_sw_uncontrolled_regen_pwrb
Do not driveTesla · BMS system
Battery Management System — Uncontrolled Regen Event (Track Mode)
What it means
This is the track-mode variant of the uncontrolled-regen protection: the BMS measured regenerative power above the maximum safe threshold during performance driving. The response is the same protective shutdown — high voltage is cut, disabling driving, charging, and low-voltage support.
Symptoms
- "Unable to drive — Pull over safely" warning
- Occurred during track or aggressive driving
- Sudden loss of power
- Single chime with a battery-cutoff warning
Likely causes (by probability)
- 1.Genuine regen spike during extreme track brakingMedium
- 2.Current/power measurement errorMedium
- 3.Inverter control faultLow
- 4.Software coordination issue in track-mode regen limitsLow
What you can check yourself
- 01End the track session and let the car cool and reset — do not immediately go back out.
- 02Note the track conditions and whether it repeats on the street; street recurrence is a red flag.
- 03Check for companion drive-unit or BMS current-sensing alerts.
- 04If it appears in normal road driving, book service before driving further.
EV systems involved in bms_a178_sw_uncontrolled_regen_pwrb
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Park it after the event. A one-off on track may be situational; any repeat — especially on the street — needs service diagnosis.
Estimated repair cost
Dealer / service center
— – —
Covered under battery or drive unit warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f027_sw_drive_iso_repeatedBattery Management System: Repeated Isolation Loss While Driving
- bms_f108_hw_bmb_alarm_self_testBattery Management System: Battery Monitoring Board Alarm Self-Test Failed
- bms_u008_limpmodeBattery Management System — Limp Mode (Reduced Power to Protect the Battery)
- bms_w052_sw_charger_miaBattery Management System — Onboard Charger Not Responding