bms_f029_sw_current_sensor_reset
Safe to driveTesla · BMS system
Battery Management System: Current Sensor Hard Reset
What it means
The BMS detected that the pack's internal current sensor went through a hard reset — essentially the sensor rebooted itself. This is logged for diagnostic purposes and usually clears as soon as the reset completes. A single occurrence is rarely meaningful; repeated resets point to a sensor or power supply problem.
Symptoms
- No customer-facing symptoms in most cases — log-only alert
- Brief moment where current readings may be unavailable
- Vehicle behavior usually unchanged
Likely causes (by probability)
- 1.Transient power glitch to the current sensorMedium
- 2.Current sensor internal fault causing self-resetsMedium
- 3.Loose connector or wiring to the sensorLow
What you can check yourself
- 01Check whether this alert appears once or repeatedly — frequency is the key diagnostic clue
- 02Look for companion current-sensor alerts (bms_f051, bms_f054) that would confirm a sensor problem
- 03Ensure the 12V battery is healthy; low-voltage brownouts can reset sensors
- 04Mention it at your next service visit if it keeps recurring
EV systems involved in bms_f029_sw_current_sensor_reset
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
A one-off reset is harmless. If it recurs alongside other current-sensor alerts, schedule a service inspection.
Estimated repair cost
Dealer / service center
— – —
Typically no repair needed for isolated events; sensor replacement is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w026_sw_ctrs_disabledBattery Management System — Battery Contactors Disabled (Service Lockout)
- bms_w108_hw_bmb_alarm_self_testBattery Management System — Battery Monitoring Board Failed Wake-Up Self-Test
- bms_a023_sw_stack_ovBattery Management System — Stack Overvoltage, Charging Disabled
- bms_a127_sw_shunt_snaBattery Management System — Current Sensor (Shunt) Signal Lost