bms_f123_sw_internal_isolation
Do not driveTesla · BMS system
Battery Management System: Low Internal Isolation
What it means
With the contactors open, the BMS measured isolation between the high-voltage system and the chassis and found it below the minimum safe threshold — and since the contactors were open, the leak is inside the battery pack itself. Internal isolation loss means moisture or damage within the sealed pack.
Symptoms
- "Service required / Schedule service immediately" message
- Driving, charging, and low-voltage support disabled
- May follow water exposure, flooding, or underbody damage
Likely causes (by probability)
- 1.Water or coolant ingress inside the battery packHigh
- 2.Damaged cell or module insulation inside the packMedium
- 3.Isolation monitoring circuit faultLow
What you can check yourself
- 01Note any history of water exposure, deep puddles, flooding, or underbody impacts — tell service explicitly
- 02Do not attempt restart cycles to "clear" an isolation fault — it can escalate
- 03Never open or probe the battery pack — internal isolation faults mean live parts may be exposed to the case
- 04Check companion isolation alerts (bms_f151, bms_f158, bms_f142) to show the full pattern
EV systems involved in bms_f123_sw_internal_isolation
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
This is a shock-safety fault inside the sealed pack. Do not drive — arrange a tow to Tesla Service.
Estimated repair cost
Dealer / service center
— – —
Pack-internal isolation work is covered under battery warranty in many cases; flood damage may route through insurance — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_u018_soc_imbalance_limitingBattery Management System — Maximum Charge Limited by Cell Imbalance
- bms_w065_sw_brick_low_capacityBattery Management System — One Cell Group Has Lost Too Much Capacity
- bms_w166_sw_ahtobecharged_imbalBattery Management System — Cell Group Charge Imbalance
- bms_a082_sw_ctr_force_openBattery Management System — Contactors Forced Open by Alert