bms_f011_hw_illegal_ctr_req
Do not driveTesla · BMS system
Battery Management System: Illegal Contactor Request
What it means
The battery management system (BMS) saw something unsafe and refused to close the high-voltage battery contactors. The contactors are the big relays that connect the battery pack to the rest of the car, so with them open the pack is effectively disconnected. The exact blocking condition is recorded in the alert log data.
Symptoms
- Car will not start or shift into Drive
- No high-voltage power available to the drive system
- 12V/low-voltage system may not be supported by the battery pack
- "Unable to start vehicle / Service required" message on screen
Likely causes (by probability)
- 1.Another underlying BMS fault is blocking contactor closure (check for companion alerts)High
- 2.Contactors commanded to close under unsafe conditions (e.g. precharge not complete)Medium
- 3.BMS control logic (CPLD) fault or corrupted stateLow
What you can check yourself
- 01Scan for other BMS alerts with Scan My Tesla or an OBD app — this code is usually a symptom of a companion fault, not the root cause
- 02Note exactly when the alert appears (at power-up, when shifting to Drive, while charging) and record the conditions
- 03Try a full vehicle power-down: exit, lock, let the car sleep for 10+ minutes, then retry
- 04Make sure the car is running the latest software version before scheduling service
EV systems involved in bms_f011_hw_illegal_ctr_req
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
The car has deliberately disconnected the battery pack, so it will not drive. Do not repeatedly force power cycles — find the companion alert and schedule Tesla Service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w142_sw_isolation_degradatioBattery Management System — High-Voltage Isolation Degraded (Warning Level)
- bms_a056_sw_standby_supply_faultBattery Management System — Standby Power Supply Fault
- bms_a148_sw_unsupported_bmb_asic_typeBattery Management System — Unsupported Cell Monitor Chip Type
- bms_f030_sw_chg_port_door_openBattery Management System: Charge Port Door Open with Welded Fast-Charge Contactor