bms_f025_sw_fc_ctrs_open_undr_ld
Safe to driveTesla · BMS system
Battery Management System: Fast-Charge Contactors Opened Under Load
What it means
During a DC fast-charging (Supercharging) session, the BMS saw the fast-charge contactors open while current was still flowing. Like the main contactors, these relays should only switch at near-zero current. This alert is mostly informational and logged so Tesla can track stress on the fast-charge path.
Symptoms
- A Supercharging session may have ended abruptly
- Usually no customer-facing message — log-only alert
- Normal driving and AC charging typically unaffected
Likely causes (by probability)
- 1.Charging session interrupted unexpectedly (cable released, station fault, emergency stop)High
- 2.Fast-charge contactor control issue inside the packLow
- 3.Supercharger station-side fault dropping the sessionLow
What you can check yourself
- 01Note whether it happened at one specific Supercharger or everywhere — station-specific points away from the car
- 02Try a different Supercharger stall or station and see if sessions complete normally
- 03Check for related fast-charge alerts (e.g. bms_f162) to give service the full picture
- 04No DIY repair applies — this is pack-internal hardware monitored by Tesla
EV systems involved in bms_f025_sw_fc_ctrs_open_undr_ld
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Informational in most cases. If fast charging keeps failing across multiple stations, schedule a service check of the fast-charge path.
Estimated repair cost
Dealer / service center
— – —
Typically no cost if no hardware damage; fast-charge path repairs are covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w168_sw_uncontrolled_regenBattery Management System — Uncontrolled Regenerative Braking Event
- bms_a083_sw_ctr_close_failureBattery Management System — Contactor Failed to Close
- bms_a168_sw_fc_full_weldBattery Management System — Both Fast-Charge Contactors Welded
- bms_f056_sw_module_temp_outlierBattery Management System: Module Temperature Outlier