All codes

bms_f036_sw_hvil

Do not drive

Tesla · BMS system

Battery Management System: High-Voltage Interlock Loop (HVIL) Fault

What it means

HVIL is a low-voltage loop that runs through every high-voltage connector in the car — if any connector is loose or unplugged, the loop breaks and the BMS shuts the high-voltage system down. This alert means the voltage on the HVIL line was out of the expected range, suggesting a connector problem or a wiring fault somewhere in the loop.

Symptoms

  • "Vehicle may not restart / Service required" message
  • Car will not drive or charge while the fault is active
  • May appear after recent service work involving high-voltage components

Likely causes (by probability)

  1. 1.High-voltage connector not fully seated (often after prior service or repair work)High
  2. 2.Damaged or corroded HVIL wiring or connector pinsMedium
  3. 3.Fault in the BMS HVIL monitoring circuit itselfLow

What you can check yourself

  • 01Think back to any recent service — a connector left slightly unseated is the classic cause
  • 02Do not attempt to reseat orange high-voltage connectors yourself; they require proper lockout procedure
  • 03Check for a companion blind-mate alert (bms_f126) that pinpoints an unseated pack connector
  • 04Record whether the fault is constant or comes and goes over bumps — intermittent points to a loose connection

EV systems involved in bms_f036_sw_hvil

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

The car may not restart once parked. Treat it as not drivable and have Tesla Service trace the interlock loop.

Estimated repair cost

Dealer / service center

— – —

Often just a connector reseat — inexpensive if caught early; covered under battery warranty when pack-related — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site