All codes

bms_f037_sw_pos_contactor

Do not drive

Tesla · BMS system

Battery Management System: Positive Contactor Fault

What it means

When the car powers up, the BMS tries to close the positive main contactor and checks that it actually closes within about two seconds. This alert means it did not — the contactor is either stuck open, welded, or its coil circuit has failed. Without the positive contactor, the pack cannot connect to the car.

Symptoms

  • "Unable to start vehicle / Service required" message
  • No drive, no charging, no high-voltage support for the 12V system
  • May hear clicking from the battery area during startup attempts

Likely causes (by probability)

  1. 1.Positive contactor mechanically stuck or worn outMedium
  2. 2.Contactor coil driver circuit or wiring failureMedium
  3. 3.Contactor welded from a prior under-load opening eventLow

What you can check yourself

  • 01Try one full power-down (exit, lock, wait 10 minutes) and a single restart — do not repeatedly retry
  • 02Check for companion contactor alerts (bms_f152 welded positive, bms_f062 contactor power) to narrow the cause
  • 03Verify the 12V battery is healthy — weak 12V can prevent contactors from pulling in
  • 04This is pack-internal hardware; there is no safe DIY repair path

EV systems involved in bms_f037_sw_pos_contactor

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

The car will not drive with a failed main contactor. One restart attempt is fine; after that, arrange a tow to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Contactor replacement is pack-internal work, covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site