bms_f051_sw_current_sensor_mia
Do not driveTesla · BMS system
Battery Management System: Current Sensor Missing (MIA)
What it means
The BMS lost communication with the current sensor (shunt) inside the high-voltage battery. This sensor measures every amp going in and out of the pack — without it the car cannot track state of charge or enforce current limits, so it shuts the high-voltage system down.
Symptoms
- "Service required / Pull over safely" message
- State of charge display may become unreliable before the alert
- Driving, charging, and low-voltage support disabled
Likely causes (by probability)
- 1.Current sensor internal failureMedium
- 2.Loose or damaged connector/wiring between the sensor and BMSMedium
- 3.Sensor power supply issueLow
What you can check yourself
- 01Do a full power-down and one restart — a transient comm glitch may clear
- 02Check for companion sensor alerts (bms_f029, bms_f054, bms_f140) to confirm a sensor-side problem
- 03Record whether the alert is constant or intermittent
- 04The sensor lives inside the battery pack — no safe DIY access; do not attempt
EV systems involved in bms_f051_sw_current_sensor_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
Pull over safely and stop. The car cannot meter its own battery without this sensor — arrange service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a148_sw_unsupported_bmb_asic_typeBattery Management System — Unsupported Cell Monitor Chip Type
- bms_f030_sw_chg_port_door_openBattery Management System: Charge Port Door Open with Welded Fast-Charge Contactor
- bms_f124_sw_bmb_comm_integrityBattery Management System: Battery Monitoring Board Communication Integrity Issue
- bms_u016_feim_delayed_ctr_closeBattery Management System — Extra Isolation Check Before Powering Up