bms_f059_sw_pack_voltage_sensing
Do not driveTesla · BMS system
Battery Management System: Pack Voltage Sensing Mismatch
What it means
The BMS cross-checks the total pack voltage against the sum of all individual brick voltages. They should agree closely; here they differed by more than 3%. That means either the pack-level voltage sensor or the brick-level measurement chain is wrong — and the car will not operate on voltage data it cannot verify.
Symptoms
- "Service required / Pull over safely" message
- Driving, charging, and low-voltage support disabled
- State of charge reading may have been erratic beforehand
Likely causes (by probability)
- 1.Pack-level voltage sensor fault or calibration driftMedium
- 2.Voltage sense harness (VSH) connection problem to one or more bricksMedium
- 3.BMB measurement fault on a moduleLow
What you can check yourself
- 01Scan with Scan My Tesla and compare reported pack voltage to the brick voltage sum — screenshot the mismatch for service
- 02Check for companion alerts like bms_f080 (internal HV disconnect) and bms_f129 (VSH connector)
- 03Try one full power-down; a transient sensing glitch may clear
- 04No DIY path — all sensing hardware is inside the sealed pack
EV systems involved in bms_f059_sw_pack_voltage_sensing
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
Pull over safely. The car cannot verify its own pack voltage, which is a hard stop — arrange service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w024_sw_ctrs_open_under_loadBattery Management System — Battery Contactors Opened Under Load
- bms_w105_sw_one_module_tsenseBattery Management System — One Module Temperature Sensor Out of Range
- bms_a017_sw_brick_ovBattery Management System — Cell Group Overvoltage
- bms_a122_sw_bms_therm_irrationalBattery Management System — Implausible Temperature Reading