All codes

bms_w152_sw_pos_contactor_welded

Do not drive

Tesla · BMS system

Battery Management System — Positive Contactor Welded Shut

What it means

The BMS has determined the positive main contactor is stuck or welded — its contacts have fused, usually from opening under heavy load. A welded contactor can't disconnect the pack on command, which is a core safety failure. The car blocks driving, charging, and 12V support, and the alert must be manually cleared after repair.

Symptoms

  • Car won't start, drive, or charge
  • May follow a history of over-current events
  • Alert persists until manually cleared during service

Likely causes (by probability)

  1. 1.Contactor contacts welded by opening under high currentHigh
  2. 2.Severely eroded/aged contactorMedium
  3. 3.A sense-circuit fault falsely reporting a weldLow

What you can check yourself

  • 01Don't attempt restarts or any high-voltage work.
  • 02Review the alert history for over-current counters that foreshadowed this.
  • 03Tow to Tesla Service — contactor replacement happens inside the sealed battery pack.

EV systems involved in bms_w152_sw_pos_contactor_welded

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

A welded contactor is an internal pack repair. Tow the car to Tesla Service — no safe DIY path exists.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site