All codes

bms_w124_sw_bmb_comm_integrity

Safe to drive

Tesla · BMS system

Battery Management System — Communication Errors With a Battery Monitoring Board

What it means

One or more battery monitoring boards are reporting communication integrity problems with the BMS — messages getting garbled or corrupted. Tesla notes this alert is primarily for logging and no impact on vehicle function is expected. It becomes interesting only if it escalates into a full "board not responding" fault.

Symptoms

  • No driver-facing symptom expected
  • Found in the alert log
  • May precede intermittent BMB communication faults

Likely causes (by probability)

  1. 1.Marginal connector or wiring between the BMS and the BMBsMedium
  2. 2.Electrical noise/interference on the communication busMedium
  3. 3.Early-stage BMB hardware degradationLow

What you can check yourself

  • 01Track whether the alert count grows over time in the logs.
  • 02Check 12V battery health if occurrences increase.
  • 03Mention it at your next service visit, especially if "BMB MIA" alerts start appearing too.

EV systems involved in bms_w124_sw_bmb_comm_integrity

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

A logging-level alert — drive normally. Worth a service mention if it becomes frequent or escalates.

Estimated repair cost

Dealer / service center

— – —

No repair expected from the log entry alone; if hardware is implicated it's often covered under battery warranty — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site