bms_f086_sw_not_ok_to_precharge
Do not driveTesla · BMS system
Battery Management System: Not OK to Precharge
What it means
The BMS ran its pre-flight checks before precharging the high-voltage bus and found a blocking condition, so it never started precharge and the contactors stayed open. Like other blocking alerts, the specific reason is in the alert log data and usually shows up as a companion fault.
Symptoms
- "Unable to start vehicle / Service required" message
- Car will not engage Drive or start charging
- High-voltage systems never come online
Likely causes (by probability)
- 1.Companion fault (isolation, HVIL, voltage sensing) blocking prechargeHigh
- 2.Charge port or interlock state preventing startupMedium
- 3.BMS logic or sensor input faultLow
What you can check yourself
- 01Scan for companion alerts first — this code is the gatekeeper, not the root cause
- 02Make sure the charge cable is fully unplugged and the charge port door is closed
- 03Try one full power-down and a single restart
- 04Note whether the car was charging, sleeping, or just driven when the alert appeared
EV systems involved in bms_f086_sw_not_ok_to_precharge
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
Not drivable until the blocking fault is found. Pull the companion codes and schedule Tesla Service.
Estimated repair cost
Dealer / service center
— – —
Resolved by fixing the underlying blocking fault; covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a075_sw_chg_disable_failureBattery Management System — Unable to Stop Charging Session
- bms_a158_sw_hvp_hvi_commsBattery Management System — High-Voltage Processor Communication Lost
- bms_f039_sw_dc_link_over_voltageBattery Management System: DC Link Overvoltage Event
- bms_f140_sw_overcurrent_senseBattery Management System: Overcurrent Sense Circuit Fault