All codes

bms_f100_hw_bmb_reset

Do not drive

Tesla · BMS system

Battery Management System: Battery Monitoring Board Power-On Reset

What it means

One of the battery monitoring boards (BMBs) inside the pack reported a power-on reset — it lost power or crashed and rebooted. While the BMB was down, the BMS had no voltage or temperature data for that module, which is why the car may have disabled the high-voltage system or shown an overheat warning.

Symptoms

  • "Vehicle system overheated / Pull over safely" message possible
  • Driving, charging, or low-voltage support may be disabled
  • May be a one-time event or repeat on every drive

Likely causes (by probability)

  1. 1.BMB hardware fault causing internal crashesMedium
  2. 2.Power supply wiring to the BMB interrupted (connector, corrosion)Medium
  3. 3.Transient voltage glitch inside the packLow

What you can check yourself

  • 01Note whether the alert appears once or on every drive cycle — repetition means hardware
  • 02Check for companion BMB alerts (bms_f050, bms_f103, bms_f104) to confirm a board-level problem
  • 03Do a full power-down; if the alert clears and stays clear, it may have been transient
  • 04All BMB hardware is sealed in the pack at high voltage — no DIY access

EV systems involved in bms_f100_hw_bmb_reset

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Do not drive

If the car disabled driving or charging, treat it as not drivable and schedule service. A single cleared event still deserves mention at your next visit.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site