bms_f062_sw_ctr_pwr_supply
Do not driveTesla · BMS system
Battery Management System: Contactor Power Supply Low
What it means
The contactors that connect the battery pack are held closed by a low-voltage supply. The BMS measured that supply dropping below the minimum needed to keep the contactors reliably closed — and a contactor that drops out under load arcs and gets damaged, so the car shuts down instead.
Symptoms
- "Service required / Pull over safely" message
- Driving, charging, and low-voltage support disabled
- May be preceded by flickering electrical behavior or 12V warnings
Likely causes (by probability)
- 1.Weak or failing 12V battery unable to hold contactor supply voltageHigh
- 2.Wiring or connector fault in the contactor power feedMedium
- 3.Contactor supply circuit fault inside the packLow
What you can check yourself
- 01Check 12V battery voltage and health (visible in Scan My Tesla or via an OBD app) — a dying 12V battery is the top cause
- 02If the 12V battery is original and 4+ years old, plan to replace it soon regardless
- 03Look for companion contactor alerts (bms_f037, bms_f038, bms_f079) to complete the picture
- 04Do not jump-start or modify the 12V system beyond a normal battery replacement
EV systems involved in bms_f062_sw_ctr_pwr_supply
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Pull over safely. Test the 12V battery first — it is the cheap, common fix — then have service confirm the contactor supply circuit.
Estimated repair cost
Dealer / service center
— – —
If it is just the 12V battery, that is a low-cost fix; pack-internal supply faults are covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w027_sw_drive_iso_repeatedBattery Management System — Repeated Loss of High-Voltage Isolation While Driving
- bms_w124_sw_bmb_comm_integrityBattery Management System — Communication Errors With a Battery Monitoring Board
- bms_a029_dsoc_limitingBattery Management System — Charge Voltage Capped (Cell Imbalance Protection)
- bms_a129_sw_vsh_failureBattery Management System — Voltage Sense Harness Fault