All codes

bms_w065_sw_brick_low_capacity

Do not drive

Tesla · BMS system

Battery Management System — One Cell Group Has Lost Too Much Capacity

What it means

The BMS tracks the calculated amp-hour capacity of each cell group ("brick") and has found one significantly below the others and under the acceptable operating capacity. A weak group drags down the whole pack and can trigger protective shutdowns of driving and charging. This is factory/service-level data, but it documents real, measurable cell wear.

Symptoms

  • Often no immediate driver-facing symptom — service-level alert
  • Possible reduced range or earlier cell-imbalance alerts
  • May escalate to charge limiting or shutdowns if the group keeps fading

Likely causes (by probability)

  1. 1.A genuinely weak/failing cell groupHigh
  2. 2.Manufacturing defect surfacing with ageMedium
  3. 3.Past cell damage (deep discharge, overheating, impact)Medium

What you can check yourself

  • 01Log cell-group capacity readings with Scan My Tesla to document the trend.
  • 02Track real-world range loss month over month.
  • 03Bring the documentation to Tesla Service — measured low capacity is strong battery-warranty evidence.
  • 04No DIY repair exists: weak cell groups are addressed inside the sealed pack by Tesla.

EV systems involved in bms_w065_sw_brick_low_capacity

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Do not drive

The car may still move, but a fading cell group can shut the car down without much warning. Get a professional pack evaluation scheduled promptly.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site