bms_f138_sw_brick_ov_warning
Safe to driveTesla · BMS system
Battery Management System: Brick Overvoltage Warning
What it means
One or more bricks reported voltage above a warning threshold — below the hard shutdown limit, but higher than the BMS likes to see. This is the early-warning version of the brick overvoltage fault, logged so Tesla can spot a developing problem before it becomes a shutdown.
Symptoms
- No customer-facing symptoms — log-only alert
- Vehicle charges and drives normally
- May appear near the top of a full charge
Likely causes (by probability)
- 1.Cell imbalance pushing one brick high near full chargeHigh
- 2.Early-stage cell degradation in one brickMedium
- 3.Voltage sense inaccuracy on the high-reading brickLow
What you can check yourself
- 01Watch brick voltages in Scan My Tesla during a charge to 100% — identify which brick runs high
- 02Try charging to 90% for a while and see if the warning stops appearing
- 03Let the car sit plugged in at high SOC occasionally so the balancer can even out the bricks
- 04If it escalates to the full overvoltage fault (bms_f017), stop charging and book service immediately
EV systems involved in bms_f138_sw_brick_ov_warning
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Keep charging normally but watch the trend. If the same brick keeps running high or the full overvoltage fault appears, schedule service.
Estimated repair cost
Dealer / service center
— – —
Usually monitored; if a brick is degrading, pack work is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w168_sw_uncontrolled_regenBattery Management System — Uncontrolled Regenerative Braking Event
- bms_a083_sw_ctr_close_failureBattery Management System — Contactor Failed to Close
- bms_a168_sw_fc_full_weldBattery Management System — Both Fast-Charge Contactors Welded
- bms_f056_sw_module_temp_outlierBattery Management System: Module Temperature Outlier