bms_f144_sw_cpld_version_wrong
Do not driveTesla · BMS system
Battery Management System: CPLD Version Not Supported by Firmware
What it means
The BMS contains a programmable logic device (CPLD) that handles safety-critical contactor control, and the installed firmware does not recognize its version. This mismatch typically happens after an incomplete or interrupted software update, or after hardware replacement with an incompatible board.
Symptoms
- "Service required / Schedule service" message
- Driving, charging, and low-voltage support disabled
- Often appears right after a software update or BMS hardware swap
Likely causes (by probability)
- 1.Interrupted or partial firmware update left versions mismatchedHigh
- 2.BMS hardware replaced with an incompatible revisionMedium
- 3.Corrupted firmware imageLow
What you can check yourself
- 01Check for a pending or failed software update in the car and retry it on a strong Wi-Fi connection
- 02Note whether the alert appeared immediately after an update — tell service, it changes the fix
- 03Do a full power-down after the update completes and recheck
- 04If software re-installation does not clear it, the hardware revision is wrong — service must resolve
EV systems involved in bms_f144_sw_cpld_version_wrong
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Not drivable while active. Try completing the software update first; if the mismatch persists, Tesla Service must reflash or replace the board.
Estimated repair cost
Dealer / service center
— – —
A firmware reflash is often no-cost; board replacement is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f164_sw_brick_soc_imbalanceBattery Management System: Brick State-of-Charge Imbalance
- bms_w026_sw_ctrs_disabledBattery Management System — Battery Contactors Disabled (Service Lockout)
- bms_w108_hw_bmb_alarm_self_testBattery Management System — Battery Monitoring Board Failed Wake-Up Self-Test
- bms_a023_sw_stack_ovBattery Management System — Stack Overvoltage, Charging Disabled