bms_w026_sw_ctrs_disabled
Do not driveTesla · BMS system
Battery Management System — Battery Contactors Disabled (Service Lockout)
What it means
The BMS has detected a condition that requires the main contactors to stay open until the car is serviced, so the pack stays disconnected: the vehicle won't start, drive, or charge. Crucially, this alert can only be cleared with Tesla's Toolbox 3 service software — no amount of rebooting will clear it at home.
Symptoms
- Car won't start
- "Service needed" warning that doesn't clear
- Unable to charge
- Often follows another serious battery alert or recent service work
Likely causes (by probability)
- 1.A prior serious fault (isolation loss, over-current, welded contactor) that latched a service lockoutHigh
- 2.Contactors intentionally disabled during previous service work and not re-enabledMedium
What you can check yourself
- 01Look back through recent alerts for the underlying fault that triggered the lockout.
- 02Confirm whether any recent service or salvage/rebuild work was done on the car.
- 03Accept that this one can't be cleared at home — it requires Tesla's Toolbox; arrange transport to service.
EV systems involved in bms_w026_sw_ctrs_disabled
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
This is a deliberate service lockout that only Tesla's tools can release. Tow the car to service and share the alert history.
Estimated repair cost
Dealer / service center
— – —
The underlying fault is covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f018Battery Management System — Insulation / Isolation Monitoring Fault
- bms_a099_sw_bmb_communicationBattery Management System — Cell Monitor Communication Problem
- bms_f002_hw_over_voltageBattery Management System — Hardware Overvoltage Trip
- bms_f079_sw_ctr_pwr_interruptedBattery Management System: Contactor Power Interrupted