All codes

bms_a023_sw_stack_ov

Do not drive

Tesla · BMS system

Battery Management System — Stack Overvoltage, Charging Disabled

What it means

The BMS has measured one or more "stacks" (larger groups of cells) inside the pack at a voltage above the allowed maximum. To protect the battery, charging is disabled until every stack comes back inside its safe window. The car typically still drives — it just will not accept a charge.

Symptoms

  • "Unable to charge — Service required" message
  • Charging sessions refuse to start or terminate immediately
  • Driving usually remains available
  • Single chime with a warning icon

Likely causes (by probability)

  1. 1.Cell imbalance that pushed one stack over the limit near full chargeHigh
  2. 2.Faulty stack voltage sensing or monitoring board channelMedium
  3. 3.Charger delivering out-of-spec voltageLow
  4. 4.Aging pack with one degraded stackMedium

What you can check yourself

  • 01Avoid charging to 100% until diagnosed — try a lower charge limit (e.g., 80%) and see if the alert stays away.
  • 02Record the state of charge at which the alert appears; consistent patterns point to a real imbalance.
  • 03Check for related BMS alerts logged at the same time.
  • 04Do not open the pack — stack-level work is high-voltage specialist territory only.

EV systems involved in bms_a023_sw_stack_ov

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Do not drive

Charging is blocked, so plan around it — schedule service before you are stuck with a pack you cannot refill.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site