All codes

bms_u002_ramp_down_active

Do not drive

Tesla · BMS system

Battery Management System: Battery Ramp-Down Active

What it means

The BMS has put the high-voltage battery into "ramp-down" — a controlled shutdown of the pack because it detected a condition requiring the battery to go offline. Power is being withdrawn in a managed way rather than cut instantly, which is why you get a warning and a short window to pull over.

Symptoms

  • "Vehicle shutting down / Pull over safely" message
  • Progressive loss of power as the pack ramps down
  • Driving, charging, and low-voltage support will be lost

Likely causes (by probability)

  1. 1.A serious companion BMS fault triggered the shutdown (check for other alerts)High
  2. 2.Critically low state of charge (see bms_u006)Medium
  3. 3.Safety condition (isolation, thermal, crash) demanding pack shutdownMedium

What you can check yourself

  • 01Pull over safely and promptly when this appears — you have limited time before power is gone
  • 02Once parked, scan for the companion alert that triggered the ramp-down; that is the real diagnosis
  • 03After the condition clears, the car may allow a restart — drive only to a safe location or charger
  • 04Do not ignore a ramp-down warning to "make it home" — power loss in traffic is dangerous

EV systems involved in bms_u002_ramp_down_active

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Pull over immediately when this appears. The underlying trigger — logged as a companion alert — determines whether the car can be driven again or needs a tow.

Estimated repair cost

Dealer / service center

— – —

Cost follows the underlying trigger fault; pack-related causes are covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site