bms_w051_sw_current_sensor_mia
Do not driveTesla · BMS system
Battery Management System — Pack Current Sensor Not Responding
What it means
The BMS has lost communication with the current sensor/shunt inside the high-voltage battery — the instrument that measures every amp flowing in and out of the pack. Without trustworthy current measurement, the BMS can't safely manage the battery, so the car may not restart, drive, or charge.
Symptoms
- Car may not restart
- "Service needed" warning
- Unable to charge
- State-of-charge or range readings may behave oddly before failure
Likely causes (by probability)
- 1.Failed current sensor/shunt inside the packMedium
- 2.Wiring or connector fault between the sensor and the BMSMedium
- 3.Low 12V supply disrupting sensor communicationsLow
What you can check yourself
- 01Verify 12V battery health before assuming a pack-internal fault.
- 02Try one full power-off and restart; record whether the alert returns.
- 03Photograph all alerts for the service visit.
- 04The sensor is inside the sealed battery pack — no DIY access; this is Tesla Service work.
EV systems involved in bms_w051_sw_current_sensor_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
Without current measurement the car can't run safely. One restart attempt, then arrange transport to Tesla Service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a077_sw_charger_regulationBattery Management System — Charger Exceeding Voltage/Current Limits
- bms_a164_sw_uncontrolled_regenBattery Management System — Uncontrolled Regenerative Braking Event
- bms_f050_sw_bmb_miaBattery Management System: Battery Monitoring Board (BMB) Missing
- bms_f142_sw_isolation_degradatioBattery Management System: Isolation Degradation Warning