All codes

bms_u014_not_enough_pwr_to_heat

Safe to drive

Tesla · BMS system

Battery Management System — Not Enough Power to Heat the Battery While Charging

What it means

In cold conditions the battery needs to warm itself before it can charge at full speed, and the car has detected that the charging source isn't supplying enough power to do that. Charging continues, but at a reduced rate until the pack reaches temperature. This most often shows up on low-power sources like a regular wall outlet in winter.

Symptoms

  • Very slow charging in cold weather
  • Message saying there isn't enough power to heat the battery
  • Charge rate improves once the pack warms up
  • Most common on 110V / low-amp charging setups

Likely causes (by probability)

  1. 1.Charging from a low-power source (standard 110V outlet) in cold weatherHigh
  2. 2.Battery pack starting very cold, needing most of the power for heatingHigh
  3. 3.A shared or overloaded circuit limiting available powerMedium
  4. 4.A failing battery heater (only if it persists on Level 2 charging)Low

What you can check yourself

  • 01Switch to a Level 2 (240V) charger if available — it has enough power to heat and charge at the same time.
  • 02Precondition the battery from the app or via scheduled departure before unplugging.
  • 03Keep the car plugged in whenever parked in the cold so it can maintain pack temperature.
  • 04If the alert persists even on a strong Level 2 source, scan for heater/coolant-related codes with Scan My Tesla.

EV systems involved in bms_u014_not_enough_pwr_to_heat

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Safe to drive

Mostly a cold-weather inconvenience, not a fault. Use a stronger charging source and preconditioning; only investigate further if it happens on Level 2 charging too.

Estimated repair cost

Dealer / service center

— – —

Normally no repair needed. If the battery heater has failed, that repair is typically covered under the battery warranty; get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site