All codes

bms_u017_charge_already_complete

Safe to drive

Tesla · BMS system

Battery Management System — Battery Already Above the Charge Limit

What it means

You tried to charge, but the battery is already at or above the charge limit you set, so the car declined to add more. Nothing is wrong — the BMS is simply respecting your charging settings. Raise the charge limit if you actually want a fuller battery.

Symptoms

  • Charging won't start because the battery is already above the set limit
  • Message suggesting you increase the charge limit setting
  • Car otherwise behaves completely normally

Likely causes (by probability)

  1. 1.Charge limit set lower than the current state of charge (e.g. after a trip or a full charge)High
  2. 2.Charge limit accidentally lowered in settingsMedium

What you can check yourself

  • 01Check the charge limit slider in the car or app and raise it if you want to charge further.
  • 02No diagnostics needed — this clears as soon as settings and state of charge match your request.

EV systems involved in bms_u017_charge_already_complete

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

Purely informational. Adjust the charge limit or ignore it — the car is doing exactly what you told it to do.

Estimated repair cost

Dealer / service center

— – —

No service or repair needed — this is normal operation based on your charge limit setting.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site