bms_u020_cannot_precharge_fc
Drive with cautionTesla · BMS system
Battery Management System — Cannot Pre-Charge for DC Fast Charging
What it means
Before fast charging starts, the car has to "pre-charge" — gently ramp up the high-voltage circuit to match the charger. The BMS couldn't complete that step, so DC fast charging is blocked. AC charging should still work, and the car drives normally.
Symptoms
- Supercharging / DC fast charging won't start
- Message suggesting you try AC charging instead
- Normal AC (home / Level 2) charging unaffected
- No drivability impact
Likely causes (by probability)
- 1.Faulty or incompatible fast-charging station equipmentMedium
- 2.Precharge circuit or fast-charge contactor problem inside the packMedium
- 3.Charge port or high-voltage wiring issue between the port and the packMedium
- 4.Software glitch cleared by a rebootLow
What you can check yourself
- 01Retry at a different stall, and then at a different charging network entirely, to rule out the station.
- 02Confirm AC charging works normally — if it does, the pack's main circuits are likely fine.
- 03Reboot the car and retry once before assuming hardware trouble.
- 04If precharge fails everywhere, schedule service — the precharge circuit lives inside the pack and is not a DIY item.
EV systems involved in bms_u020_cannot_precharge_fc
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Drive normally and charge on AC for now, but get it checked if more than one DC station fails — long trips depend on fast charging.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a177_sw_energy_buffer_sizeBattery Management System — Energy Buffer Too Large (Range Estimate Degraded)
- bms_f071_sw_sm_transcon_not_metBattery Management System: State Transition Blocked
- bms_f163_sw_contactor_wot_countBattery Management System: Contactor Wide-Open-Throttle Stress Event
- bms_w025_sw_fc_ctrs_open_undr_ldBattery Management System — Fast-Charge Contactors Opened Under Load (Log)