All codes

bms_w025_sw_fc_ctrs_open_undr_ld

Safe to drive

Tesla · BMS system

Battery Management System — Fast-Charge Contactors Opened Under Load (Log)

What it means

The contactors dedicated to DC fast charging opened while current was flowing. This alert is primarily informational logging for service, but it records stress events on the fast-charge path — the kind of thing that, if repeated, wears contactors and can eventually block Supercharging.

Symptoms

  • Usually no immediate symptom — service/logging alert
  • Possible history of fast-charging sessions ending abruptly
  • May coincide with fast-charging faults

Likely causes (by probability)

  1. 1.Fast-charge sessions interrupted under load (unplugged mid-session, station fault)High
  2. 2.A charging-station fault cutting power abruptlyMedium
  3. 3.Wear developing in the fast-charge contactorsLow

What you can check yourself

  • 01End fast-charging sessions cleanly through the screen or app rather than yanking the cable under load.
  • 02Note whether sessions at specific stations end abnormally.
  • 03If fast charging starts failing, mention this logged alert at service.

EV systems involved in bms_w025_sw_fc_ctrs_open_undr_ld

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

Informational for now. Charge normally, but let service know if fast-charging sessions keep ending unexpectedly.

Estimated repair cost

Dealer / service center

— – —

No repair expected from the log entry alone; if contactor wear is confirmed, that is often covered under battery warranty — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site