All codes

bms_a149_sw_missing_config_block

Drive with caution

Tesla · BMS system

Battery Management System — Configuration Block Missing

What it means

The BMS cannot find a valid configuration block — the stored data that tells it what pack and hardware it is managing. Without it, the BMS cannot initialize its parameters properly. This is a provisioning or data-corruption problem, typically seen after hardware swaps or failed programming.

Symptoms

  • "Vehicle configuration mismatch — Service required" message
  • Single chime with a warning icon
  • Possible restrictions on driving or charging
  • Usually appears after BMS or pack service, or a failed update

Likely causes (by probability)

  1. 1.BMS or pack replaced without programming the configuration blockHigh
  2. 2.Corrupted configuration memoryMedium
  3. 3.Interrupted software update or provisioning sessionLow

What you can check yourself

  • 01Note any recent service or software update timing and report it — that is the likely root cause.
  • 02A full sleep cycle is worth one try; corrupted reads sometimes recover.
  • 03Do not attempt programming yourself; configuration requires Tesla Toolbox access.
  • 04Check for companion alerts (pack config mismatch, missing part number).

EV systems involved in bms_a149_sw_missing_config_block

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Schedule service to have the configuration reprogrammed. The car may drive, but the BMS is running without its full map.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; typically a programming fix at Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site