All codes

bms_w002_hw_over_voltage

Do not drive

Tesla · BMS system

Battery Management System — Hardware Over-Voltage (Battery Shut Down)

What it means

Pack voltage climbed above the maximum the hardware allows, so the BMS opened the main contactors and shut the high-voltage system down. The car can't drive, charge, or support the 12V system from the pack until the condition clears. Over-voltage is taken seriously because it can damage cells and electronics.

Symptoms

  • Car won't drive or charge
  • "Service needed — pull over safely" warning
  • Often appears during or right after charging
  • May appear with other voltage-related BMS alerts

Likely causes (by probability)

  1. 1.A charging fault pushing voltage too high (charger or external station issue)Medium
  2. 2.Failing cell groups or sensing errors causing runaway voltage readingsMedium
  3. 3.A defective voltage-sense circuit or BMS hardware faultMedium
  4. 4.Transient grid/charger surge during a charging sessionLow

What you can check yourself

  • 01Stop charging and don't attempt to drive; note whether the alert appeared while plugged in.
  • 02Photograph the alerts and record which charger was in use.
  • 03Try a full vehicle power-off and restart once — if the alert returns, don't keep cycling it.
  • 04Arrange service or a tow; pack voltage diagnosis involves lethal high voltage and is not DIY-safe.

EV systems involved in bms_w002_hw_over_voltage

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Don't drive or charge until it's inspected. Tow it to Tesla Service — over-voltage protection events need professional diagnosis.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site