All codes

bms_w011_hw_illegal_ctr_req

Do not drive

Tesla · BMS system

Battery Management System — Contactor Close Request Blocked by Safety Logic

What it means

A hardware safety chip (the CPLD) inside the battery management system has detected a fault condition and is refusing to let the main battery contactors close. With the contactors open the pack stays disconnected — the car can't drive, charge, or support the 12V system. The specific blocking reason is stored in the alert log data.

Symptoms

  • Car won't start or drive
  • Unable to charge
  • Often appears together with a more specific BMS alert
  • May follow a recent fault, repair, or 12V power event

Likely causes (by probability)

  1. 1.Another active fault (isolation, over-current, welded contactor) legitimately blocking the contactorsHigh
  2. 2.A false trigger from low 12V supply or a wiring fault in the sensing circuitMedium
  3. 3.Internal BMS hardware fault in the safety logic itselfLow

What you can check yourself

  • 01Look for companion alerts — this code usually rides along with the real problem.
  • 02Verify the 12V battery is healthy before assuming a pack fault.
  • 03Pull the alert log with Scan My Tesla if available; the extra signal data helps Tesla pinpoint the blocking condition.
  • 04Don't attempt any high-voltage work — this requires Tesla Service diagnosis.

EV systems involved in bms_w011_hw_illegal_ctr_req

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

The car is protecting itself and won't power the high-voltage system. Identify the companion fault and get it to Tesla Service — a tow is the safe move.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site