bms_w031_sw_precharge_res_hot
Do not driveTesla · BMS system
Battery Management System — Precharge Resistor Overheated
What it means
Every time the car powers up the high-voltage system, a precharge resistor gently limits the inrush current before the main contactors close. The BMS detected that this resistor got hotter than its maximum operating temperature — usually because the contactors were cycled open/closed too many times in a short window. Until it cools, the car won't start or charge.
Symptoms
- Car won't start — "service needed" message
- Often follows repeated attempts to power on or start the car
- May clear after the car sits and cools for a while
- Unable to charge while active
Likely causes (by probability)
- 1.Too many contactor close/open cycles in a short time (repeated start attempts, an underlying fault cycling the contactors)High
- 2.An underlying fault (like a welded contactor or short) forcing repeated precharge attemptsMedium
- 3.A failing precharge resistor or circuitLow
What you can check yourself
- 01Stop cycling the car — let it sit powered off for 30+ minutes and try once more.
- 02If it happens again, look for the root-cause alert that's making the contactors cycle.
- 03Note how many start attempts preceded the alert.
- 04If it recurs without repeated start attempts, the precharge circuit needs Tesla Service — it's inside the pack and not DIY-serviceable.
EV systems involved in bms_w031_sw_precharge_res_hot
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Give the car a long rest and try once. If the alert returns, stop attempting restarts and have it towed to service — something is overworking the precharge circuit.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a069Battery Management System — Low Voltage (12V/16V) Support Fault
- bms_a098_sw_bmb_data_integrity_lossBattery Management System — Cell Monitor Data Integrity Lost
- bms_f001_hw_over_currentBattery Management System — Hardware Overcurrent Trip
- bms_f077_sw_charger_regulationBattery Management System: Charger Regulation Fault