All codes

bms_w033_sw_crash

Do not drive

Tesla · BMS system

Battery Management System — Crash Detected (Battery Pyrofuse Blown)

What it means

The BMS detected that the battery pack lost power to the contactors while they were closed — the signature of the pyrofuse firing during a collision. The pyrofuse is a one-shot safety device that instantly disconnects the high-voltage battery in a crash. Once blown, the car can't drive, charge, or support the 12V system until the fuse is replaced during service.

Symptoms

  • Car completely loses high-voltage power after an impact
  • "Service needed — pull over safely" warning
  • Car won't restart or charge
  • Visible collision damage in many cases

Likely causes (by probability)

  1. 1.A collision triggered the pyrofuse as designedHigh
  2. 2.A severe electrical fault interpreted as a crash eventLow
  3. 3.Pyrofuse firing without a significant impact (rare, but reported on some older packs)Low

What you can check yourself

  • 01If there was any impact — even a moderate one — treat the high-voltage system as live and damaged; keep clear of orange cabling.
  • 02Do not attempt to restart repeatedly or bypass anything.
  • 03Arrange a tow to Tesla Service; pyrofuse replacement requires opening the pack and is never a DIY job.
  • 04Document the incident for insurance — this repair is often part of a collision claim.

EV systems involved in bms_w033_sw_crash

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Deep dive: what owners should know

The warning-level sibling of the crash pyro codes, BMS_W033 logs the same underlying event — the battery detected a crash signature and fired or attempted to fire the pyro disconnect — but frames it as a warning state rather than a hard fault, which usually reflects where in the detection sequence the event resolved. In practice, owners meet this code after low-speed impacts, curb strikes severe enough to trigger crash sensors, airbag deployments that did not happen, and occasionally after nothing anyone can remember — because parking-lot taps and pothole strikes at the right frequency do reach crash sensors. The BMS saw the crash signal, did or partially did its disconnect dance, and logged the event for the record. What the car does next varies with how much of the sequence completed. When the pyro actually fired, the high-voltage system is permanently disconnected until the pyrofuse is replaced — the car may still wake and show this history, but it will not drive, and towing to service is the only path. When the sequence was interrupted or the sensor signal spurious, the car often continues operating with this warning in its history, and the honest question becomes whether anything actually happened. That question is worth asking out loud at service, because crash-sensor thresholds, mounting condition, and wiring all get examined in the same visit, and an overly hair-trigger crash sensor is a legitimate finding. For buyers evaluating a used car, this code in the history is a direct question to the seller: what hit this car, and when? The answer — or the absence of one — tells you a great deal about the vehicle's past and the seller's honesty.

Severity

Do not drive

The car's crash-safety system did its job. Tow — don't drive — to Tesla Service for pyrofuse replacement and a full high-voltage inspection.

Estimated repair cost

Dealer / service center

— – —

Often handled through collision insurance; warranty coverage depends on cause — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site