hvbatt_a237_bmsassertedcpfaultline
Do not driveTesla · HVBATT system
High-Voltage Battery — BMS Declared a Charge Port Fault (Welded Contactor)
What it means
The BMS has asserted the charge port fault line, which is its way of hard-blocking charging. The documented trigger is a welded fast-charge contactor — a high-voltage relay that is stuck closed when it should be able to open. That is a hardware fault inside the battery pack, not something software can fix.
Symptoms
- "Unable to charge — Disconnect and retry" message
- Charging will not start on AC or DC
- Fault persists across chargers and locations
- Warning chime when attempting to charge
Likely causes (by probability)
- 1.Welded (stuck-closed) fast-charge contactor inside the battery packHigh
- 2.Fault line wiring issue between the BMS and charge portLow
- 3.BMS mis-detecting contactor state (sensor fault)Low
What you can check yourself
- 01Unplug and retry once as the car suggests, but expect it to come back
- 02Check for related contactor alerts that confirm the diagnosis
- 03Do NOT attempt to open the battery pack or bypass contactors — welded-contactor work is service-only
- 04Arrange service before the pack runs low, since you cannot recharge
EV systems involved in hvbatt_a237_bmsassertedcpfaultline
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
You can drive on remaining charge but cannot recharge. Head toward service — a welded contactor is internal pack hardware that only Tesla can address.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a249_acjbcpneutralrelayweldedHigh-Voltage Battery — Charge Port Neutral Relay Welded (ACJB)
- hvbatt_a734_bp1cacimbalancelimitingHigh-Voltage Battery — Cell Capacity Imbalance Limiting Performance (Section 1)
- hvbatt_a745_bp1socimbalanceHigh-Voltage Battery — State-of-Charge Imbalance, Max Charge Capped at 50%
- hvbatt_a248_acjbcplinerelayweldedHigh-Voltage Battery — Charge Port Line Relay Welded (ACJB)