All codes

bms_a077_sw_charger_regulation

Safe to drive

Tesla · BMS system

Battery Management System — Charger Exceeding Voltage/Current Limits

What it means

During a charge session, the charging hardware pushed voltage or current beyond the limits the BMS had set. The BMS logs this so service can see the charger was not regulating properly. It is an informational flag — the BMS protective limits kept the pack safe.

Symptoms

  • No driver-visible symptoms
  • Silent alert visible mainly in service logs
  • Charging may have ended early or restarted
  • May correlate with a particular charging station

Likely causes (by probability)

  1. 1.External charging equipment (EVSE or DC station) regulating poorlyHigh
  2. 2.Onboard charger regulation faultLow
  3. 3.Communication lag between the BMS and charger during load changesLow

What you can check yourself

  • 01Note which station or home EVSE was in use; if it only happens on one unit, avoid that unit.
  • 02Check whether the alert appears across different chargers before suspecting the car.
  • 03Keep software current — charge-control coordination is updated frequently.
  • 04No action needed for a single occurrence.

EV systems involved in bms_a077_sw_charger_regulation

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Safe to drive

No immediate concern — the BMS protected the pack. Only escalate if the alert repeats across multiple chargers.

Estimated repair cost

Dealer / service center

— – —

Usually points to external charging equipment (no vehicle cost); vehicle-side faults are covered under battery warranty in many cases.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site